Service Hotline:400-0000-000
Shenzhen Xintian source Electronics Co., Ltd.
Address:Hongfa Industrial Park 1, 5th Floor, Shiyan Town, Baoan District, Shenzhen
Fax:0755-29833253
Phone:0755-27650903
Cell phone:13728612903
Contacts:Wang
Caixian maintenance divided into two parts outside the machine and dryer. Machine outside the main wipe clean the surface of the display screen, you need to open the machine to clean the display housing.
1) anti-glare color display screen outside the clean surface, antistatic coated with an extremely thin coating of chemicals, usually remove the dust on the monitor screen, remember to turn off the monitor's power should unplug the power cord and signal cables show line, with a soft, dry cloth to gently wipe outward from the center of the screen, the screen wipe method should gently wipe the inner radially outward, if the screen surface is dirty, you can use a small amount of water, moist cotton or lens paper to clean, Do not wipe with a chemical solution of alcohol and the like. In addition to the display, but also frequently used brushes remove dust and dirt on the monitor cabinet, try not to wipe with a wet cloth.
Clean 2) remove its internal dust, monitor manufacturers must ask professionals to operate, do not attempt to open the display cover, if the off time is not long, in front of the graphite layer on the tube and pressure cap will have residual high pressure front display , then the energy of this high pressure provides sufficient wounding, use thick rubber wires shorting display circuit board edge and high-pressure metal plate inside of the cap, the release of residual charge, in order to avoid serious consequences. Disconnect the monitor when dust inside the monitor power display with a Phillips screwdriver to remove the four corners of the screws, remove the display back cover. First paintbrush to monitor cleaning, dusting key parts are tubes, ignition coil and tube tail circuit board. Another tube is a glass device, carefully damaged, the display depending on the circuit board inserted in the seat tube tail pipe, some depending on the circuit board plug and seat tube tail pipe bonded together, forced Banxia may damage the tubes, Please operation watch out.